I did an uninstall and re-install but I get the same results.I want it to shoot through my topo surface and then apply a boundary later.It looks fine in Composer but doesnt show up in C3D - only straight line.
Civil 3D Subassembly Composer Install And ReWould like the same outcome as the Generic Link Code - LinkSlopetoElevation. The elevation of this point should be derived from a point that is using Slope and Delta Y from point P12 (see attached). Must be at least 1m from the bottom of SubBase with a 5:1 slope. Id like to be able to select my offset alignment for my ditch bottom. Have a link from this point extend at a slope to the Target Surface to complete the foreslope. Civil 3D Subassembly Composer How To Complete TheI cant quite picture how to complete the links from the DitchOffset point. This may be complicated but the diagram identify what Im trying to do. When I try to write in an expression under Link Codes I get an error. Is there a way to create conditional codes without the use of decisions. Have super eop targeting a feature line with elevations, but when i check section editor gutter slope doesnt match pavement slope. Civil3D 2013 Windows 7, 64 bit Intel i7 2600 3.40Ghz 16 GB RAM Nvidia Quadro 600. Civil 3D Subassembly Composer Download It FromWhere is the subassembly composer We have Civil3D 2013, and my understanding was that the subassembly composer was supposed to automatically install in 2013 as opposed to previous years when you had to download it from the Subscription Center. I would rly love to get.pkt file with working model as example, or at least get some usefull tip. This I know. Ive attached an image from the Autodesk file that shows multiple point codes per link and point for the DaylightStandard Civil 3D Stock SA. Which point codes must I use in my subassemblies to ensure I can create corridor surfaces properly down the road For example the DaylightStandard SA shows. P3 shows: DitchOut, Hinge, HingeCut P3 also shows: Daylight, DaylightFill P4 Dayltight, DaylightCut If Im building something similar in the Subassembly Composer what the heck do I focus in on for my point code. I will have issues with my Corridor surfaces down the road if I dont do this properly up front. Ive seen examples where the Input Output Parameters you define a string for the coding, is this to apply multiple codes to a point or a link. But is there a way to go the other directionI want to use certain SAs that come with OOB C3D -- but I want to customize them. ![]() How do I setup the target surface so that when I import the SA into my drawing, I can link it to that surface and have it cut off 1 m above the surface. If I start a new project, they work for a while, but once I have worked for several minutes, they become disabled again.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |